DIY Crafts – How to Make Crepe Paper Flower Bouquet !
In this master class with step by step photos, you will learn how to make clove of corrugated paper with your own hands, crafts suitable for both children and adults.
To produce a flower, you need the following materials and tools at hand:
1. corrugated paper in two colors: primary (for flowers) and green for the leaves and stems;
3. Melt the glue;
Step 1: Make as revealed carnation flower.
Since carnations on one bush can have multiple colors, to reveal, to varying degrees, need to do a few different buds, the first of which – to fully disclose. For its production need strips of paper width of about 2.5 cm and about 5 cm in length.
Cut strips of petal.
Stretch the tab in the upper part.
Finely chop the edge.
Such petals should be about 10 pieces. (The more, the more luxuriant bud).
We begin to gather a flower at random folding the first petal accordion.
He is joined by a second folded petal.
Each subsequent lobe fix the thread to the composition is not scattered.
Collected all the petals – the central part of the bud is ready.
Then do the petals to the outer part of the bud. They need to pitch the same length but a lesser width (twice).
Cut petal and stretch it to the top.
Cut into small lobe region.
Such petals also have to order 10 pieces.
We fix them around a central bud, slightly tilting – carnation flower is ready.
Step 2: Collect flower.
Then do sepals. They need a small strip, the edge of which you want to cut teeth.
Stretch in the upper part, forming a recess.
Curl up in the bowl.
Interfere in her flower, fixing glue.
Making stem from the strip the desired length and width of the order of 1.5 cm.
Twist the strip into a tube, fixing the edge of the adhesive.
Putting the flower and stem.
Making additional sepals from strips of 0.5 to 1 cm.
Sharpen them at both ends and pulling the middle, forming a groove.
Glue in place the junction of the stem and flower.
Step 3. Make the floor of a full-blown bud.
As already described ways to cut out the petals and add them accordion.
Prepare a bowl of sepals and somewhat related to hinder in place of petals. We put a little deeper – so that the bud looked just dissolved.
Glue to the stem and surrounded by additional sepals.
Step 4: Make a tight buds.
For the manufacture of such strips need bud corrugated paper both colors. Length – 5 cm width – 1.5 cm.
Curl stacked on each other in the middle of the strip and form the grooves on both halves.
Fold in half, slightly pulling forward maroon paper and overtighten the thread at the base of the flower.
Step 5. Collect bush carnation.
Everybody got on separate stalks buds should be collected in a single composition. For this we use here such strips.
When stretched, they are very close fitting to the stem, which is what we needed.
Glue the stem to the stem and place the joint winding strip as a bandage.
According to this principle connect all the stems into the bush.
Three stem together.
Four of the stem.
Then do the leaves. Cut pointed at both ends leaves width of the order of 0.5-0.8 cm.
Fasten them in place stems joints – get ready clove.