DIY Crafts : How to Make Crepe Paper Flower Bouquet !
Today we will do a very simple and beautiful bouquet of white tulips from sweets . This bouquet can safely give for any occasion! It not only will be a long time to please, but the candy inside each flower will serve as dessert. So, wizard class called flowers from crepe paper with your hands, making crafts represented in the form of step by step with photos.
we need to manufacture the sweet beauty:
• corrugated paper white and green;
• long wooden skewers;
• white thread;
• teip green tape;
• decorative paper lilac;
• lilac organza;
• green ribbon;
• glue gun.
First, you need every piece of candy attached to a wooden leg.
To do this, insert the blunt end of the skewer in the middle of a “skirts” candy so as not to touch a piece of candy . Then fasten the edge of the adhesive tape around the middle of the “skirts” and begin to tightly wrap the leg. Swathes of about 5 cm wooden skewers.
Each tulip will be composed of three white petals. Therefore, the corrugated paper mode for as many bands width of 5 cm, how much will be flowers. In the master class of 13 pieces, so paper mode to 13 bands and cut each into three equal segments.
Each segment is folded into halves and then twisted in the middle of the two halves in opposite directions twice.
Fold the halves together to form with the volumetric lobe. That is, one side is convex and the other concave. So we formed a place for candy.
Put candy on a skewer in a petal and begin to wrap the lower part of a white thread in the same place where he started winding tape.
Thus three petals have uniformly around the entire candy . The thread is cut off in the end and fasten a pistol glue.
Now green paper bandwidth mode to 4 cm. Each cut into four segments of equal length and form sharp corners on both sides.
Fasten the tab to the leg so that it looked out over a flower 3 cm.
Now you need to hide all the flaws, which were formed during the formation of the flower. Green paper on the mode bandwidth of 1 cm across the corrugation and stretch. In this case, you can use the green-tape teip.
Fasten the end of the tape just under the bud, to hide the strip threads and winding it down gradually down. The adhesive tape can be fixed at this stage. Wrapped in such a way the whole leg, fasten the end of the tape.
Get ready here are tulips.
You can now wrap up half of tulips in lilac organza, which previously needed to iron. Cut the fabric into squares the size of 10×10 cm. Fold one square diagonally, while not necessarily exactly. We place the middle of the bud.
Tightly wrap the two ends of the triangle tulip organza. Fix the ends of the adhesive on the bud.
Now form a bouquet of flowers in the required order. Sticks will first hang around in different directions.
As a result, holding the hand position stems crossing, we fasten it with tape. Then all the sticks wrapped with tape to the end to form an even and dense stem bouquet.
To hide the tape, wrapped the leg teip-tape.
Now it is very easy to zavernёm bouquet wrapping paper. It is necessary to cut out a square and place the bouquet on the diagonal.
Both ends of the wrap, very tight bandages from the middle of the bow ribbons. One corner of the paper to buckle outwards, fixing the edge of the adhesive.
We get the original and sweet bouquet of white tulips.