DIY Handmade Flowers – Handmade Crocuses from foamirana !
Crocus – this is one of those flowers, which can be very easy to do from foamirana. Therefore, this workshop is suitable even for beginners, will be presented pattern and step by step photos.
For the manufacture of crocus foamirana own hands, we need:
• cardboard template;
• Floral wire;
• ready stamens;
• thick corrugated paper;
• foamiran pink, green and white;
• glue gun.
Rubbings templates for our flower . Middle, will consist of the stamens of foamirana and from finished. Petal is the size of 4,5h2,5 cm and height 3.5 cm stamens.
On pink foamirane draw out with the help sewed blank to 6 times the petals. From white foamirana cut out three stamens pattern.
Preheat the iron on the full power and attached to the edge of the crown stamens only a couple of seconds. It must become more bulk.
Then treat one lobe, spread it on a hot iron for 2-3 seconds. Remove immediately and very quickly we place on the corrugated paper. Properly foamiran dent in the table. Strips of paper should go along the petal. Instead of paper you can use the pier, if any. We treat only one side lobe to be located inside the flower . If not pre-heat the petal on the iron, just press it in the paper, we do not get the desired texture. And at a heat treatment it will be maintained for a long time. Main printed paper folds in just heated Thomas.
As the stamens have become more prominent, glue them to the floral wire so that if they were dismissed from the inside.
Then fasten between the stamens one finished.
Begin assembly crocus. Petal is attached to the base of the stamens. Then evenly distribute two more petals. The second layer of the other three petals spread in between the first layer of petals.
From foamirana be cut on the eye sepal with six ends. His warm up on the iron, and then strung on a wire and are attached to the base of the crocus.
As you can see, the crocus is very simple to manufacture.