Pinwheel Jewelry Plant Stake – Garden Crafts

0
617

Translucent plastic, metal wire and teardrop beads create lovely, colorful garden stakes.

Microsoft Word - Garden Crafts eBook

Materials:

• AMACO® Friendly Plastic® — one each:
Turquoise/Blue
Avocado/Black
Purple/Black
Swirl/Blue
Fuchsia/Black
Burnt Orange/Black
Orange Copper/Black
Gold/Black
• AMACO® Fun Wire™ — Clear/Silver (24 & 18 Gauge)
• 1/8″ Eyelets and Eyelet Tool
• 1/8″ Leather Hole Punch and Hammer
• Teardrop Bead
• Silver Head Pin and Jump Ring
• Round Nose Jewelry Pliers
• AMACO® Needle Tool
• Scissors

Steps:

1. Cut the plastic into triangle pieces and place one of each color on the baking sheet in the pattern
shown below. Make different size pinwheels by cutting different size triangles.

2. Soften the Friendly Plastic® according to the package instructions. Using a needle tool, start in
the center of the softened plastic and slowly draw outward in a spiral motion. Allow the cut lines
to seal back together. Cool the plastic and remove it from the baking sheet.

3. Make a 1/8″ hole into the center of the plastic pinwheel with the leather punch and a hammer.
Place a 1/8″ eyelet into the hole and secure it with the eyelet tool.

4. Cut a 32″ length of 24 gauge wire and wrap it around the pinwheel in a random pattern. Secure
the wire on the back.

5. Cut a 36″ length of 18 gauge wire, bend in half around the round nose pliers and twist tightly
leaving a loop at one end. This forms the base or stake. Insert the twisted wire stake through the
eyelet center of the pinwheel. Slide the pinwheel up against the loop. Cut a 16″ length of 18
gauge wire. Make 4 wraps with it around the twisted wire stake, just behind the pinwheel to
secure it into place. Form a random design with the remainder of the wire. See photo.

6. Cut a 16″ length of 22 gauge wire. Make 4 wraps with it around the twisted wire stake just under
the wraps made with the 18 gauge wire. Twist and spiral the remainder of this wire around the
stake as shown in the photo. Tightly wrap the end of the wire around the stake to secure.

7. Grip the stake with the pliers just behind the pinwheel and bend the wire 45 degrees.

8. Place the teardrop bead onto the head pin and form a loop at the point of the bead with the round
nose pliers. Add the bead where desired using a jump ring.

Microsoft Word - Garden Crafts eBook

By Jana Ewy