DIY Wedding Decoration – How to Make Wedding Ring Pillow !
In this simple master class with step-by-step photo-instruction we will make a very nice little cushion for the rings with our own hands for the wedding. The main thing is to determine the color range of this wedding accessory and then it will only be necessary to select the materials.
We will need to sew a cushion:
• Satin fabric;
• two-sided satin ribbon 1 cm wide;
• threads for the color of the fabric;
• paper for the template;
• a pencil;
• pins with ears;
• glue gun.
The size of the cushion is 12×12 cm, so we cut out a square of the same size from paper. The fabric is folded inward with the front side and draw a pencil outline of the paper template on the fabric. Cut out both layers of fabric, deviating from the painted edge 1 cm. Also from the tulle cut out a square with a size of 14×14 cm, like cut pieces of fabric. All the details need to be ironed.
Now remove the top layer of fabric with the drawn square. For the remaining square we put the tulle so that the edges coincide. Cut the two-sided tape length of 48 cm and cut it in half. One end of each segment should be cut obliquely and scorched by a cigarette lighter. The unbaked end of the tape is glued in the middle of one side to the allowances to the edge. We glue the second tape on the other side in the same way.
Tapes need to be folded and fixed so that they do not creep over the edges of the square. Cover the second square of the fabric and fasten both layers of fabric along the allowances with pins. Instead of pins, it can be sealed with a seam.
We begin to sew from the right upper corner from the right to the left with a stitch or sewing machine. Stitches are made of the same length and stitched strictly along the drawn line.
Sew on the line not to the end and leave a length of up to 4 cm.
Through this hole, we turn the blank for the pillow out. Corners can be straightened by any sharp object, we untie the tape.
Through the hole fill the middle of the sintepon. First push small pieces into each corner, and then completely fill the pillow.
The hole is stitched in very short stitches. The end of the thread is hidden under the seam.
After filling the pillow with a sintepon, we tie both ends of the tape to the bow . The tulle layer should be on top of the knotted knotted bow.
Now thread the thread in the needle and at one end tie the knot, fixing it between the layers of fabric in one of the corners. Then string the bead, skip 2 seams and pass the needle through the third seam. Again string the bead and stitch the whole edge.
DIY Wedding Decoration
In addition, decorate the cushion with tulle flowers. Simply cut off a strip of tulle of any length and width, fold it in half, and sew the edge with an offset seam.
We pull the tulle on a string and twist it into a flower that should turn out to be quite magnificent. Then we sew the bottom part of the flower to fasten the middle. Only then we fix and cut the thread.
We decorate the top right corner of the pillow with these three colors.
We also decorate the lower left corner with half-beads in staggered order.
DIY Wedding Decoration
So simply you can make an original wedding cushion for the rings with your own hands.