How to sew a piggy skirt !

2012 Holiday Gift Guide for Crafters-97

Materials Needed:

 1/2 yard denim

 16 contrasting fabric

 Thread

 Sewing machine

 2 buttons

 1/2″ wide elastic

Let’s Start

1. For the front of the skirt, you will need to have 3 denim pieces and 2 contrasting fabric pieces, 11.5cm wide, 38 cm long (4.5″x15″).

2012 Holiday Gift Guide for Crafters-95

2. For the back you’ll need 1 denim piece 38cm x 38cm (15″ x 15″).

2012 Holiday Gift Guide for Crafters-96

3. Those measurements will make a skirt that is approximately a size 3. By adjusting the widths and lengths you can make it for any size. Just measure your child’s (or your) waist, halve it, add an inch on either side for seam allowance, and that is the width of your back piece. For the front piece, you want the denim pieces to add up to make that measurement (eg. If its 18″ you will cut 3 pieces of denim 6″ wide each, and cut your 2 contrasting pieces the same). 4. Pin together and sew the front skirt pieces together using a 1/4 cm seam allowance. The denim pieces should be the outside panels and the centre panel. You will end up with a piece like this:

2012 Holiday Gift Guide for Crafters-98

5. I cut my seams with pinking shears to reduce fraying, then pressed the seams open. 6. Next, mark the centre point of your pleats. 7. Fold the denim either side so your pleat fabric is concealed inside the pleat. Pin the pleat into place. Once you have both pinned it should look something like this:

2012 Holiday Gift Guide for Crafters-99

8. Machine baste across the top of your pleats to keep them in place. 9. Fold the top of the skirt over 1/2cm (1/4″) and press. Fold over 2 1/2cm (1″) and press. This creates a casing which will be decorative on the front of the skirt and will coordinate with the elastic casing on the back of the skirt.

2012 Holiday Gift Guide for Crafters-100

10. Sew the casing and top stitch along the top of the skirt. 11. Put the front section aside, take the piece of denim for the back of the skirt, and create a casing for the elastic using the same measurements as for the front piece.   2012 Holiday Gift Guide for Crafters-101

12. Stitch the casing in place then topstitch along the top of the back piece so it looks the same as the front. 13. Cut your elastic approximately 2/3 size of the width of the skirt (mine was 15″ so I cut the elastic 10″) 14. Thread the elastic through the casing and pin it into place at each end

2012 Holiday Gift Guide for Crafters-102

15. Pin the sides together and sew the side seams. 16. I don’t have an overlocker (serger) so I finished them by using a zig zag stitch, but for you lucky ladies who have overlockers, that would be the ideal way to finish the seams. 17. Hem your skirt to the desired length, then hand sew your buttons onto the front of the skirt, over the top of your pleats and you’re done.

2012 Holiday Gift Guide for Crafters-103
Piggy Skirt